Engine oil pump replacement
Multi-lobe rotary pumps are the most common type of oil pump. Externally mounted oil pumps usually have the oil filter attached to the pump body.
If the oil pump is fitted to the outside of the engine, you may be able to reach it from under the bonnet.
If not, apply the handbrake and support the engine end of the car on axle stands. Chock the other wheels.
On externally mounted pumps, remove the oil filter (See How to drain engine oil and remove filter). On engines where the pump is inside the crankcase, drain the engine oil and re move the sump pan.
Removing the sump pan can involve removing or raising the engine. If so the repair is best left to a local main dealer. On certain cars it may also mean taking off the gearbox. If you are in any doubt, consult a dealer.
Removing, checking and refitting the pump
Put a tray or rag under the engine to collect any drips of oil, and unscrew the bolts securing the pump to the engine block.
As you withdraw the pump, mark the position of the pump drive shaft so it can be put back in exactly the same way.
The drive shaft sometimes drives the distributor as well (check in the service manual). On such engines, remove the distributor cap and mark the position of the rotor arm.
If the rotor arm is moved at any time — if the engine is turned, for example the ignition timing will have to be reset (See Adjusting the static timing).
On externally mounted pumps with a skew gear, the gear can usually be put back in any position.
Use a rag dipped in petrol and, if necessary, a scraper tool to carefully remove dirt and any gasket remains from the pump mounting flange.
Be careful not to damage the mounting faces on the pump or engine. Usually only externally mounted pumps have a gasket.
Make sure the working parts of the pump are thoroughly cleaned (See Checking the oil pump).
On externally mounted pumps, fit a new gasket to the pump flange, and keep it in position with a smear of gasket sealant while you locate the drive shaft.
Make sure the drive shaft is correctly aligned before you push the pump back into position. If it fails to locate properly, withdraw the pump and move the drive shaft very slightly, then try again.
Refit and tighten the pump securing nuts or bolts to the torque-wrench setting recommended in the service manual for your car.
On an internally mounted pump, refit the sump pan and replace the engine oil.
On both types, always fit a new oil filter (See How to drain engine oil and remove filter). Also prime the pump with clean engine oil before you refit it to the car.
Run the engine very gently until the oil pressure builds up to normal, then check for oil leaks.